Die Finishing Specialist Training Leader

Physical Requirements Sits occasionally (up to 30% of the time)Stands constantly (greater than 70% of the time)Walks constantly (greater than 70% of the time)Drives seldom (up to 10% of the time)Lifts up to 10 lbs from the floor to knuckle height seldom (up to 10% of the time)Lifts up to 10 lbs between the knuckle and chest level occasionally (up to 30% of the time)Lifts up to 20 lbs between knuckle and chest level seldom (up to 10% of the time)Lifts up to 30 lbs between knuckle and chest level seldom (up to 10% of the time)Lifts up to 40 lbs between knuckle and chest level seldom (up to 10% of the time)Carries bilateral frequently (up to 70% of the time)Pushes / pulls greater than 10 lbs of force occasionally (up to 30% of the time)Climbs stairs occasionally (up to 30% of the time)Climbs step ladders seldom (up to 10% of the time)Works at heights above floor level frequently (up to 70% of the time)Bends at waists occasionally (up to 30% of the time)Twists at waists frequently (up to 70% of the time)Crouches squats occasionally (up to 30% of the time)Kneels occasionally (up to 30% of the time)Reaches knees to shoulders frequently (up to 70% of the time)Reaches above the shoulders seldom (up to 10% of the time) You must meet the following requirements within 14 days of the closing date of this announcement. The experience may have been gained in either the public, private sector or volunteer service. You must meet the screen-out element Ability to Instruct, normally addressed at the beginning of the online questions. To meet the screen-out element, applicants must have: I have education in the above areas but have not yet had an opportunity to perform any of them on the job . In addition, you must also obtain an average score of two (2) for the following elements for this position as addressed through the online question in order to be considered minimally qualified. Your application will be evaluated in the following areas: Operation of Machine Tools, Ability To Use Hand Tools for Machine Shop, Technical Practices (theoretical, precise, artistic), Ability To Use Shop Drawings, Measurement and Layout, and Knowledge of Metals.
This position is located in the Coining Section, Product Division, Plant Manager Office, Manufacturing Department, United States Mint in San Francisco, CA, Department of the Treasury.