System Protection Control Craftsman I & II

In order to qualify for this position, your resume must provide sufficient experience and/or education, knowledge, skills, and abilities, to perform the duties of the specific position for which you are being considered. Your resume is the key means we have for evaluating your skills, knowledge, and abilities, as they relate to this position. Therefore, we encourage you to submit a thorough resume that directly relates to this position. Applicants must meet the requirements of the Office of Personnel Management (OPM) Job Qualification System for Trades and Labor Occupations (X-118C). Although a specific length of time and experience is not required for most trade and labor occupations, you must show through experience and training that you possess the quality level of knowledge and skill necessary to perform the duties of the position at the level for which you are applying. Qualification requirements emphasis is on the quality of experience, not necessarily the length of time. Your qualifications will be evaluated on the basis of your level of knowledge, skills, abilities and/or competencies in the job elements and screen out listed below. This job has a screen-out factors which will be used to determine minimum eligibility for this job. Applicants who do not receive a minimum of two points on this screen-out element(s) will be found ineligible. The screen-out element for this position is defined as operating computer-controlled relay test system for commissioning, maintenance and diagnostic fault simulation on micro-processor and electro-mechanical transmission lines, transformers, bus and breaker failure relays, and removing line protection from service, performing diagnostic and functional tests, and returning line protection to in-service condition without more than normal supervision. Failure to meet this Screen out Element will result in an ineligible rating. In addition to the screen-out element you will be evaluated on the following Job Elements through your resume and responses to the on-line assessment questionnaire: Ability To Do The Work Of The Position Without More Than Normal Supervision Ability To Use Hand and Power Tools -Electronics Ingenuity (Ability To Suggest and Apply New Methods) Knowledge of Equipment Assembly, Installation, Repair, etc. Theory of Electronics Trouble shooting (Electronic Equipment) Use of Test Equipment: Electronics If your knowledge and ability in the SCREEN OUT factor above is not sufficient, you will receive no further consideration. In preparing your application, describe in detail the experience and training which you have had that specifically prepared you for this job and to perform the duties described for this job. Experience should be clearly described and documented in your resume. The qualifications reviewer will not assume performance of such duties by Job Titles alone. This position has a selective placement factor, failure to meet this requirement(s) will result in an ineligible rating. Must possess a current valid U.S. motor vehicle operator’s license from state of residence. Operate motor vehicles, including 1-1/2 ton pickups, sedans, snowmobiles, or van-type trucks. WORKING CONDITIONS:Work is performed primarily indoors. Some work will involve travel to remote sites or substations, and may be performed in adverse weather conditions which includes extremes of temperature. The employee may be exposed to electrical hazards of all voltages existing in the BPA system, and will be expected to work occasionally on substation equipment at heights 40 feet above the ground. The work environment will occasionally include high noise levels or exposure to toxic or hazardous substances (i.e., acids, solvents, PCB’s, mercury, pesticides, etc.) that could, if precautions are not followed, pose a health risk. Proper respiratory and safety equipment shall be worn when hazardous substances are being handled. PHYSICAL CONDITIONS:Incumbents must be physically and mentally able to efficiently perform the essential duties of the position, with or without reasonable accommodation, without hazard to themselves or others. “Experience” refers to paid and unpaid experience. Examples of qualifying unpaid experience may include: volunteer work done through National Service programs (such as Peace Corps and AmeriCorps); as well as work for other community-based philanthropic and social organizations. Volunteer work helps build critical competencies, knowledge, and skills; and can provide valuable training and experience that translates directly to paid employment. You will receive credit for all qualifying experience, including volunteer experience.
This position is located with Bonneville Power Administration, in Covington District (TFC) and Salem District (TFL), Transmission Field Services (TF), Transmission Services (T). A successful candidate in the System Protection Control Craftsman I & II position will provide technical direction and instructions to SPC personnel, trainees, and other crafts.