Electrician (Construction)

In order to qualify for this position, your resume must provide sufficient experience and/or education, knowledge, skills, and abilities, to perform the duties of the specific position for which you are being considered. Your resume is the key means we have for evaluating your skills, knowledge, and abilities, as they relate to this position. Therefore, we encourage you to submit a thorough resume that directly relates to this position. Applicants must meet the requirements of the Office of Personnel Management (OPM) Job Qualification System for Trades and Labor Occupations (X-118C).Although a specific length of time and experience is not required for most trade and labor occupations, you must show through experience and training that you possess the quality level of knowledge and skill necessary to perform the duties of the position at the level for which you are applying. Qualification requirements emphasis is on the quality of experience, not necessarily the length of time. Your qualifications will be evaluated on the basis of your level of knowledge, skills, abilities and/or competencies in the job elements and screen out listed below. This job has a screen-out factors which will be used to determine minimum eligibility for this job. Applicants who do not receive a minimum of two points on this screen-out element(s) will be found ineligible. The screen-out element for this position is: The ability to successfully perform the work of a High Voltage Electrician is defined as performing the majority of the following duties under normal supervision: installing, modifying, and construction of electrical sub-stations, transformer banks, fiber splicing, and power generation/transmission/distribution equipment, and systems at 11,000 to 500,000 volts. Failure to meet this Screen out Element will result in an ineligible rating. In addition to the screen-out element you will be evaluated on the following Job Elements through your resume and responses to the on-line assessment questionnaire: Ability To Do The Work Of The Position Without More Than Normal Supervision Ability To Use and Maintain Hand Tools (Electrical Work) Ability To Use Electrical Drawings Knowledge of Electrical Equipment Technical Practices (theoretical, precise, artistic) Theory and Instruments (Electrical, Electronic) Used in Shop and Trade Practices Trouble shooting (electrical) If your knowledge and ability in the SCREEN OUT factor above is not sufficient, you will receive no further consideration. In preparing your application, describe in detail the experience and training which you have had that specifically prepared you for this job and to perform the duties described for this job. Experience should be clearly described and documented in your resume. The qualifications reviewer will not assume performance of such duties by Job Titles alone. WORKING CONDITIONS: Working conditions vary depending on tasks. Most work is performed outside in all weather conditions, but some work is done inside under normal shop conditions. Work is performed around energized equipment, such as switchboards containing critical control circuits where carelessness could cause a serious system disturbance or outage. Work is done in energized Substations at various heights in excess of 100 feet, such as on steel framework, platforms, and ladders adjacent to energized high-voltage equipment. The Electrician must frequently work on surfaces which are slippery due to insulating oil or ice. Installing conduit, pulling cable, working in oil circuit breaker (OCB) tanks, etc., involves working in restricted and cramped quarters. Approved respiratory and safety equipment shall be worn when hazardous substances are being handled (oil, acid, and solvent fumes, etc.). At times, work may be physically demanding. The work environment will occasionally include high noise levels or exposure to hazardous substances (i.e., mercury, acids, solvents, PCB’s, etc.) that could, if precautions are not followed, pose a health risk. Potential exposure to radiation could occur if assigned to work at the WNP2 plant (Ashe and Hanford). Emergencies, critical system conditions, or outage limitations may require that work be systemwide, done at night or under serious time pressures. System priorities may require extended periods of overtime including working weekends and holidays. OTHER REQUIREMENTS: Subject to call for emergency work at any time. Drive two and four-wheel drive vehicles, which may include towing various equipment trailers, normally used in substation maintenance and construction. Be able to wear protective apparel such as respirators when required for worker safety. During the first year, new hires will be required to successfully complete the Power System Electrician orientation training. This includes evaluating employees on both written and performance tests. “Experience” refers to paid and unpaid experience. Examples of qualifying unpaid experience may include: volunteer work done through National Service programs (such as Peace Corps and AmeriCorps); as well as work for other community-based philanthropic and social organizations. Volunteer work helps build critical competencies, knowledge, and skills; and can provide valuable training and experience that translates directly to paid employment. You will receive credit for all qualifying experience, including volunteer experience. CTAP/ICTAP candidates: To be considered “well qualified” you must meet all of the requirements as described in this section. You must meet all qualifications and eligibility requirements by the closing date of this announcement.
This position is located with Bonneville Power Administration (BPA), in the Specialty Services (TFHS) organization of Construction and Maintenance (TFH), Transmission Field Services (TF), Transmission Services (T). A successful candidate in the Electrician (Construction) position will perform installation and adjustment, to include erection of new facilities or removal of old facilities.